The ribonucleic acid of the new coronavirus is RNA, and the detection of the ribonucleic acid of the virus is the detection of RNA.
Moreover, nucleic acid testing is an important means to confirm whether the new coronavirus is infected.
At present, nucleic acid detection of the new coronavirus mainly uses RT-PCR nucleic acid detection kits.
Simply put, the inspectors will use nucleic acid extraction kits to extract nucleic acids from patient specimens and put the extracted nucleic acids into nucleic acid detection reagents for replication.
If the test result is negative, it means that the patient may not be infected with the new coronavirus. If the test is positive, it means that the patient is infected with the virus.
The Cell medical COVID-19 Antigen Self-Test (At Home Kit) provides quick results in the convenience of your home. An easy COVID-19 infection detection solution, this 15-minute test can be done anytime, anywhere. Detect multiple variants.
Cell medical Covid 19 Rapid Test Kit home test
For consecutive (repeated) tests, simply test yourself twice within 3 days, at least 24 hours apart (and no more than 48 hours apart). A single test is available if you have symptoms.
Please read the full instructions included in the box carefully before starting the test.
This self-test kit is suitable for asymptomatic people, and the nose and throat are swabs to determine whether they are infected.
Asymptomatic infection refers to people who carry the virus but have no symptoms.
If you test negative for COVID-19
Most likely you were not infected when you were tested. However, a negative result does not guarantee
You do not have COVID-19.
Covid 19 Rapid Test Kit, including extraction tube holder, sealed packaged test strips, extraction buffer bags, extraction tubes, garbage bags, sealed packaged flocked swabs, and instructions;
How do I use the Covid Rapid Test Kit home self-test kit?
- Open the package and take out the test card.
- Using the Flocked swab from the kit, insert the entire soft tip of the swab into the nostril.
- Rub the inside of the nostril with a cotton swab. Make at least 5 large circles. Don’t just spin the swab.
- Using the same swab, repeat steps 1 and 2 in the other nostril. Each nostril must be wiped for about 15 seconds.
- Install the stirrer on the extraction tube, drop two drops into the sample hole of the test card, and start the timer.
- After performing the test, be sure to wait at least 15 minutes for your results to be available.
- Test again in three days (with at least 36 hours between tests).